Checking DoodleLabs Connection

Follow the steps below to check the connection between the DoodleLabs Ground Unit and the Air Unit:

1. Power Check

• Place the antennas on the DoodleLabs Ground Unit, power the Drone and the Ground Unit, and connect the Ground Unit to the Ethernet adapter on the ground control station.
• The first point to check is the DoodleLabs Ground Unit power status.
  • If you encounter power issues, the Ethernet adapter icon will display a red X over it. There are two potential sources for power issues:
    • The external battery.
    • The Ground Unit itself.
  • If the Ground Unit is powered properly, the red X will disappear, and the icon will show that it is connected to a network.

i

If the issue persists, contact the manufacturer for assistance.

Figure *. Checking DoodleLabs Connection

2. Configuration Window Access

• The second step is to check the DoodleLabs configuration window via a web browser:
  • After entering the IP address of the Ground Unit and Air Unit in the web browser, you should see the DoodleLabs login window.
  • If you cannot access the login window, refresh the browser and try again. Keep in mind that the Air Unit inside the drone takes longer to boot than the Ground Unit.

i

If you still cannot access the login window after several refresh attempts, contact the manufacturer.

Figure *. Configuration Window Access